Quote:
Originally Posted by Zombie1
They look to fit real well. How much space did you gain from them?
|
Thanks guys. Since they're ABS, they conform rather easily. This specific set is +4cm(1.5") for each flare, doubled for total gain. I believe it was ETADRAFT that made the discovery that they mock up to the existing flat portion of each wheel-well with little effort, which is where I also decided to mount them. I used rivnuts(stainless, which broke 4 tools before I was able to get this far) and they seem to hold nicely - 10 mounting points per flare. Still haven't had time to get further than what these pictures show, but I'm confident that they'll be easy to manipulate around curves with heat. Once I begin, I'll take before and after photos. Regardless, I'm quite happy with the outcome so far.