That looks like everything I received. It all looks of high quality & was very well packaged. I'll be giving Peter a call over the next few days to ask him for tips on fitment, including;
- Approximate torque values?
- As per the pics I only received one bolt, but two sets of nuts & washers. Is this right (am I reusing one already on the car?) or should I have received two to mount the bracket?
- Do I need to prime the cooler/hoses once installed or does the pump do all the work and flush out the air?
- Should I run the new hoses approximately over the same path as the existing ones?
- Where should the split corrugated hose be used?
- Where should the small blue hose be used?
- Is any cutting of the wheel arch liner or front area required?
Thanks again.
PS, nice laser cutting of "ADVAN" on the bracket. Pity they can't do the centre of the "D"
