|
|
|
08-31-2023, 03:30 AM | #1 |
Private
12
Rep 50
Posts |
Schroth quick fit or buckets and harness?
I recently picked up a 135i that I plan to use as a track car.
I can’t decide on whether to get a schroth quick fit harness, or to go all out and get buckets and harnesses. What are your guy’s thoughts? |
08-31-2023, 06:46 AM | #2 |
Second Lieutenant
202
Rep 275
Posts |
If you are setting it up as a track car only, get the best seats and harness available. I use the 4-point quick fit Schroth harness in my street car and it's fine for that.
|
Appreciate
1
Dirty1thirty512.00 |
08-31-2023, 09:48 AM | #3 |
Enlisted Member
24
Rep 37
Posts |
I debated this concept as well for when I do TT’s in NASA. I will most likely get proper seats & harness along with a cage. The quick fit is nice, but HPR doesn’t allow 4 point harnesses, only 5 or greater.
|
Appreciate
1
Dirty1thirty512.00 |
09-01-2023, 12:23 AM | #4 | |
Private
12
Rep 50
Posts |
Quote:
Was consider the fx1 corbeau’s. Will bucket seats make the seat lower? I sit kind of high in this car. And I’m not super tall. |
|
Appreciate
0
|
09-01-2023, 12:24 AM | #5 | |
Private
12
Rep 50
Posts |
Quote:
Any cage suggestions? |
|
Appreciate
0
|
09-01-2023, 12:35 AM | #6 |
Enlisted Member
24
Rep 37
Posts |
Personally, I was looking at Autopower. If I recall correctly, the RSR harness bar is too low. A guy I met through the local SCCA chapter uses the autopower roll bar for his 135i in TT’s. An instructor of mine the local BMWCCA gave me a reference to have someone weld/assemble a cage so I might go that route.
If NASA/SCCA/BMWCCA has any local chapters near you, I’d reach out to the folks there. They probably know someone local that could fabricate a cage or install a bolt in cage. |
Appreciate
0
|
09-01-2023, 12:39 AM | #7 | |
Private
12
Rep 50
Posts |
Quote:
I was considering auto power also but they look so cheap. I’ve never seen one in person but they look like the spot that they bolt to the car with uses a small plate. That seems possibly problematic if it actually rolls. |
|
Appreciate
0
|
09-01-2023, 12:47 AM | #8 |
Enlisted Member
24
Rep 37
Posts |
Fe1rx noted the issue with the RSR cage somewhere on this forum. He’s a great resource on the forums. He ended up making his own cage.
I’ve read mixed reviews about the autopower regarding regarding the area it bolts onto on this forum as well. From what I’ve been told, the guy racing in TT in SCCA has had no issues. But of course, he hasn’t rolled over… I’m leaning towards reaching out to a local fab shop that produces cages for TT’s/W2W racing. Unfortunately, there aren’t a lot of pre built cages for the 1er. |
Appreciate
0
|
09-01-2023, 12:49 AM | #9 | |
Private
12
Rep 50
Posts |
Quote:
|
|
Appreciate
0
|
Post Reply |
Bookmarks |
Thread Tools | Search this Thread |
|
|