|
|
|
07-29-2013, 03:17 PM | #1 |
Colonel
167
Rep 2,409
Posts |
rub or no rub?
Do you think I can install m3 control arms without rubbing?
Setup... arc8 pss 235, pretty low on coils. Shouldve thought of this earlier since I already placed an order for the control arms, luckily it hasnt shipped yet. |
07-30-2013, 11:36 AM | #2 |
Supreme Allied Commander
4017
Rep 55,434
Posts
Drives: F80 M3
Join Date: Mar 2007
Location: Santa Barbara, AP, Brembo, GIAC, Koni, Ohlins, Performance Friction, www.hpautosport.com
|
That looks like my 18x10 F14s up front and my KWs... I would be very suspect of the control arm kit working. How much room do you have on the outside edge? Might need a 3mm spacer if you can still have some tuck.
-Mike |
Appreciate
0
|
08-01-2013, 11:23 PM | #3 |
Brigadier General
1793
Rep 4,166
Posts
Drives: BMW M3
Join Date: Feb 2011
Location: PA, USA
|
Yikes that's pretty close ...
Bring some 3-5mm spacers with you when the parts get installed ...otherwise you may not be able to drive out of there.
__________________
2024 BMW M3 Sedan Frozen Pure Grey II/Fjord Blue, 6MT
Past: 2021 Z4 M40i Frozen Grey II/Black Alcantara | 2017 F30 340i Mineral Gray/Coral Red, 6MT | 2011 E92 335i Le Mans Blue/Black, 6MT |
Appreciate
0
|
08-02-2013, 12:12 AM | #4 | |
Colonel
167
Rep 2,409
Posts |
Quote:
Thats with 3mm spacers... I would probably need 5mm spacers with camber plates. I probably wont do it just for the m3 control arms. Thanks for your input. |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|