|
|
|
09-15-2011, 06:22 PM | #357 | ||
Major General
2821
Rep 7,645
Posts |
Quote:
Quote:
|
||
Appreciate
0
|
09-15-2011, 06:38 PM | #358 |
Colonel
122
Rep 2,695
Posts |
What a monster 60' time! Does seem there is a ten second pass in the car, pity it's not a 135!
__________________
.-=[ Kenny ]=-. 1999 BMW M Coupe 10.775 @ 134.35 mph w/1.600 60' (Best 136.07 mph) 25th August 2004. +2010 X5 35D+
Check out the 1Addicts Drag Racing Standings and Drag Racing 101. |
Appreciate
0
|
09-15-2011, 07:28 PM | #360 |
Brigadier General
169
Rep 3,093
Posts |
|
Appreciate
0
|
09-15-2011, 09:22 PM | #363 |
Major General
401
Rep 9,156
Posts |
I thought he went forced induction to pull out those numbers. Very impressive. I looked into Zeds seriously a while back, I think they are great cars but shame they are NA which limits their modding potential. 9.5k isn't small money either, any reason why he didn't go for the twin/turbo setup which make a lot more power? 303kw is very respectable though but he could have had GTR power
|
Appreciate
0
|
09-18-2011, 07:16 PM | #364 |
Colonel
122
Rep 2,695
Posts |
Private track day at Sydney Dragway, Sunday 18th September 2011.
I headed out to WSID with Fly135 (Jason) on Sunday to take part in a private track day organised by the Skyline Australia club. Great club, really well organised day. The weather was not kind, being quite humid and very hot (first day over 30 degrees in Sydney this year!), but the skies stayed blue. The Density Altitude was 2148 feet. Not so good. This is the first time I've taken my 135 to the drag strip and I was keen to get some baseline information. The race scales tell me my raceweight (me in car) is 1619 kgs (3569 lbs). Not too bad considering it was full weight (nothing removed) plus a rollcage. I had about 1/8th tank of fuel. From my extensive dyno work at Advan Performance I know the car is making ~ 394 rwhp. My performance modifications include PROcede Rev 3 tune, AR downpipes and Vishnu PWM methanol kit. The car is running the stock runflats on stock wheels, with stock diff (no LSD). I wanted to see what I could do with runflats at the drag strip, knowing that heavy car, relatively high horsepower, manual tranny and runflats aren't a recipe for world shattering ETs! I also wanted to experiment with the PROcede Rev 3 launch control features. These include a flat shift function as well as a two step/antilag function. Testing at Advan Performance showed that my car will build ~ 6 psi of boost when the two step is set to 4500 RPM. Higher RPM would see the boost increased, perhaps to ~ 9 psi at a higher setting.
__________________
.-=[ Kenny ]=-. 1999 BMW M Coupe 10.775 @ 134.35 mph w/1.600 60' (Best 136.07 mph) 25th August 2004. +2010 X5 35D+
Check out the 1Addicts Drag Racing Standings and Drag Racing 101. |
Appreciate
0
|
09-18-2011, 07:20 PM | #365 |
Colonel
122
Rep 2,695
Posts |
Kenny's pass journal for WSID track day
As always I too a pocket notebook and analysed each pass before deciding on a plan of attack for the next pass. After getting home I entered the information into a Pass Journal to better analyse what the 135 wants in order to optimise the short time, ET and Trap Speed. Kenny's Pass Journal for Sunday.
__________________
.-=[ Kenny ]=-. 1999 BMW M Coupe 10.775 @ 134.35 mph w/1.600 60' (Best 136.07 mph) 25th August 2004. +2010 X5 35D+
Check out the 1Addicts Drag Racing Standings and Drag Racing 101. |
Appreciate
0
|
09-18-2011, 07:27 PM | #366 |
Major General
401
Rep 9,156
Posts |
Thanks for the update Kenny. Great effort considering your still running the open diff and run craps. I expected the mph to be slightly higher though.
|
Appreciate
0
|
09-18-2011, 07:30 PM | #367 |
Colonel
122
Rep 2,695
Posts |
Analysis of passes.
Some analysis of the passes, both at the track and later on at home revealed some information. On that day with DA of 2148', the trap speed was consistent at 113.x MPH, with a best of 114.11 MPH. Knowing the car's raceweight of 3569 lbs and trap speed of 113.x MPH we know how much power it makes on the big black dyno on that day. Experience soon showed that the twostep/antilag function of PROcede Rev 3 cannot be exploited with runflats. The rubber simply cannot hold any amount of boost from the hit. After three attempts (decreasing the twostep RPM limit) I turned this fucntion off for the remainder of the day. This is an exciting prospect for those with manual transmissions who have good street radials or even drag radials. With this sort of much better rubber the twostep function will come into it's own. Making 6-9 psi of boost on the hit will see awesome short times (and therefore ETs) once the drag radials hold the hit. The PROcede Rev 3 flatshift function worked a treat. Those passes where I did not use flatshift compared to the passes where I did show that the car clearly profits from the function. The throttle does not close between shifts and the half track and trap speeds are higher. The timers at each interval also show that flatshift is great for your ET too. I can wholeheartedly recommend PROcede Rev 3 flatshift/twostep (Launch Control) for any 135 manual transmission owners who want to go drag racing. Having turned off the twostep I then experimented by varying my launch RPMs manually. After each pass I would note the resulting short time of the car and how it got out of the hole. Surprisingly even with stock runflats the optimum launch RPMs were at 5000 RPM. It took until 5500 RPM until the covers blew off at the hit. When you consider how narrow and how hard runflats are, then I was surprised that the car wanted 5000 RPM to launch.
__________________
.-=[ Kenny ]=-. 1999 BMW M Coupe 10.775 @ 134.35 mph w/1.600 60' (Best 136.07 mph) 25th August 2004. +2010 X5 35D+
Check out the 1Addicts Drag Racing Standings and Drag Racing 101. |
Appreciate
0
|
09-18-2011, 07:32 PM | #368 |
Colonel
122
Rep 2,695
Posts |
Best Timeslip of the day.
The best ET was 12.814 with a 2.101 short time. The best trap speed was 114.11 MPH with half track 89.78 MPH. Best Timeslip from Sunday.
__________________
.-=[ Kenny ]=-. 1999 BMW M Coupe 10.775 @ 134.35 mph w/1.600 60' (Best 136.07 mph) 25th August 2004. +2010 X5 35D+
Check out the 1Addicts Drag Racing Standings and Drag Racing 101. |
Appreciate
0
|
09-18-2011, 07:34 PM | #369 |
Major General
401
Rep 9,156
Posts |
Kenny you sure you needed to get the car off the line at 5000rpm? It sounds like that's way too high. How much wheelspin did you get? I would have experimented with some softer launching. How did you launch the car to get the 2.1 short time?
|
Appreciate
0
|
09-18-2011, 07:39 PM | #370 | |
Colonel
122
Rep 2,695
Posts |
Quote:
Probably would have been a bit higher without the hot weather but I'm not unhappy with it.
__________________
.-=[ Kenny ]=-. 1999 BMW M Coupe 10.775 @ 134.35 mph w/1.600 60' (Best 136.07 mph) 25th August 2004. +2010 X5 35D+
Check out the 1Addicts Drag Racing Standings and Drag Racing 101. |
|
Appreciate
0
|
09-18-2011, 07:43 PM | #371 | |
Colonel
122
Rep 2,695
Posts |
Quote:
I am sure I could get that short time down with further practice on the runflats, but would be over the moon if I managed a 1.9x. It's a challenge with a clutch and runflats I can tell you! However having said that I'm not interested in trying to get the ultimate short time with runflats. Next time I'll use drag radials so I can exploit the twostep and get out of the hole under boost. The short time and ET will tumble with better rubber.
__________________
.-=[ Kenny ]=-. 1999 BMW M Coupe 10.775 @ 134.35 mph w/1.600 60' (Best 136.07 mph) 25th August 2004. +2010 X5 35D+
Check out the 1Addicts Drag Racing Standings and Drag Racing 101. |
|
Appreciate
0
|
09-18-2011, 08:03 PM | #372 | |
Brigadier General
169
Rep 3,093
Posts |
Quote:
Last edited by JB4-335; 09-18-2011 at 08:10 PM.. |
|
Appreciate
0
|
09-18-2011, 08:31 PM | #373 |
Banned
91
Rep 3,070
Posts
Drives: A boring one...
Join Date: Oct 2008
Location: Australia
|
Great to see Kenny, and thanks for putting up all your info!
I too am surprised to see you launch at such a high rpm. Is that with dumping the clutch or slipping? I would have thought dumping it would see nothing but wheelspin, just like you found out with the flat shifting on the Procede. ps- You have an aftermarket FMIC too? |
Appreciate
0
|
09-18-2011, 08:44 PM | #374 | |
Colonel
122
Rep 2,695
Posts |
Quote:
__________________
.-=[ Kenny ]=-. 1999 BMW M Coupe 10.775 @ 134.35 mph w/1.600 60' (Best 136.07 mph) 25th August 2004. +2010 X5 35D+
Check out the 1Addicts Drag Racing Standings and Drag Racing 101. |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|