|
|
|
07-12-2020, 11:01 AM | #1 |
Enlisted Member
12
Rep 42
Posts |
Wastegate rattle
so i have the dreaded wastegate rattle.its the rear turbo making the rattle.so today i attempted to tighten the actuator arm which should be a 10mm wrench to back the nut off and the 10mm wrench doe not fit.so i picked up a set of mini wrenches from crappy tire which has 4mm -11mm.very poor quality,rounded off edges on the flats.
Anyway 10mm too big,9mm too big,8mm too small.wtf? The turbo's were replace under warranty a while back.my question is did they use a smaller nut on the replacement turbos?could it be imperial instead of metric? |
Post Reply |
Bookmarks |
Thread Tools | Search this Thread |
|
|