|
|
|
01-05-2020, 02:27 PM | #1 |
Lieutenant
120
Rep 475
Posts
Drives: 2009 Crimson Red 135i
Join Date: Mar 2008
Location: Sterling, Va
|
Rear Wheel Bearings - Inserting Axle
Hi All - replacing the rear wheel bearings on my 2009 BMW 135i. I have the new bearings installed, but when I go to install the half shafts (axles) they go in OK, and I can thread on the castle nut, but when I tighten it to spec, there is a gap on the inside where the axle meets the bearing.
Anyone else have this issue? I assume the axle is supposed to contact the bearing. Confused! Thanks. |
01-18-2020, 07:13 PM | #2 |
Lieutenant
120
Rep 475
Posts
Drives: 2009 Crimson Red 135i
Join Date: Mar 2008
Location: Sterling, Va
|
To answer my own question, I wasn't looking at this right. It was seating just fine.
|
Appreciate
3
|
Post Reply |
Bookmarks |
Thread Tools | Search this Thread |
|
|