BMW 1 Series Coupe Forum / 1 Series Convertible Forum (1M / tii / 135i / 128i / Coupe / Cabrio / Hatchback) (BMW E82 E88 128i 130i 135i)
 





 

Post Reply
 
Thread Tools Search this Thread
      01-05-2020, 02:27 PM   #1
joeo
Lieutenant
120
Rep
475
Posts

Drives: 2009 Crimson Red 135i
Join Date: Mar 2008
Location: Sterling, Va

iTrader: (0)

Garage List
2009 BMM 135i  [9.50]
Rear Wheel Bearings - Inserting Axle

Hi All - replacing the rear wheel bearings on my 2009 BMW 135i. I have the new bearings installed, but when I go to install the half shafts (axles) they go in OK, and I can thread on the castle nut, but when I tighten it to spec, there is a gap on the inside where the axle meets the bearing.
Anyone else have this issue? I assume the axle is supposed to contact the bearing. Confused!
Thanks.
Appreciate 0
      01-18-2020, 07:13 PM   #2
joeo
Lieutenant
120
Rep
475
Posts

Drives: 2009 Crimson Red 135i
Join Date: Mar 2008
Location: Sterling, Va

iTrader: (0)

Garage List
2009 BMM 135i  [9.50]
To answer my own question, I wasn't looking at this right. It was seating just fine.
Appreciate 3
Suprgnat2281.00
dtla1826.00
Post Reply

Bookmarks

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -5. The time now is 10:02 AM.




1addicts
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
1Addicts.com, BIMMERPOST.com, E90Post.com, F30Post.com, M3Post.com, ZPost.com, 5Post.com, 6Post.com, 7Post.com, XBimmers.com logo and trademark are properties of BIMMERPOST