|
|
|
04-22-2015, 06:50 AM | #1 |
"Detailing Devil Dog"
310
Rep 409
Posts |
Buffing Difficult Angles on the Side of A Vehicle
In this 40-minute video, I discuss and show my technique for buffing complex curves and angles on the side of a vehicle. I discuss and show how to negotiate the various angles, dips and curves that you may encounter. The thing that I stress in this video is that you have to constantly pay attention to what the polisher is doing when you are working on areas like this. The sound of the polisher will constantly be changing (or talking to you as I call it), which gives you clues on how to proceed. It is this "talking" that the polisher is doing that will be your clue as to how much pressure to use and how to angle the polisher while buffing.
There is a LOT of watching that you need to do as I am working the polisher. Notice how I don't necessarily use a cross-hitch pattern of buffing like I would on a flat and open surface. Notice that I tend to use short buffing strokes in the dips. Notice that the pad NEVER stops rotating, which will happen if you apply too much pressure. You ALWAYS want the pad to rotate or the effectiveness of the machine will be greatly diminished. Watch and pay attention while learning! Products and equipment used: Orange 6" Hex-Logic pad (for a novice, a 5.5" Hex-Logic pad is a MUCH better, easier to use and preferred option). Optimum Compound II Porter-Cable 7424XP orbital sander (or polisher if you want to call it that) 16 x 24 Eagle Edgeless Blue Super Plus Microfiber Towel Enjoy! The Junkman
__________________
"Marines - Making the other guy die for his country for over 200 years."
|
04-22-2015, 09:00 AM | #2 |
Colonel
173
Rep 2,346
Posts |
JUNKMAN! I follow your youtube account always useful info.
__________________
Mods:-Berkexhaust -alpinaB3flash -CobbAP -Cobb FMIC -ER charge pipe tialQ bov -M3 front sway bar -M3 subframe bushings -M3 front upper and lower control arms -M3 guide rods -M3 rear upper control arms -Mfactory LSD -defiv lockdown kit -TC Kline SA coilovers /camber plates- HP rear toe arms |
Appreciate
0
|
04-22-2015, 10:33 AM | #3 |
"Detailing Devil Dog"
310
Rep 409
Posts |
Thanks for watching.
__________________
"Marines - Making the other guy die for his country for over 200 years."
|
Appreciate
0
|
04-28-2015, 01:47 PM | #4 |
Second Lieutenant
43
Rep 205
Posts |
I'm about to polish my car with a DA for the first time this weekend, I've been watching a ton of videos on it. This is a good one, and I'm about to watch your Novice ones... thanks!
|
Appreciate
0
|
04-28-2015, 03:09 PM | #5 |
"Detailing Devil Dog"
310
Rep 409
Posts |
I can guarantee you that my novice videos will make more sense to you than any that you'll watch on You Tube.
__________________
"Marines - Making the other guy die for his country for over 200 years."
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|