|
|
|
06-30-2018, 12:45 PM | #1 |
Colonel
441
Rep 2,038
Posts
Drives: 2017 F80 M3 ZCP BSM 2012 E82 1
Join Date: May 2012
Location: Boston, MA
|
2E0F Valvetronic Adjustment Error
Had this a while back and had the system reprogrammed, went away and was back to normal for a while. Same code now back w engine malfunction and permanent code being stored 2E0F.
Must be something else that needs replacing or fixing since the reprogramming only held it at bay for a few months. Any ideas? High rev start ups, loud starts from cold, drivability seems normal just get engine malfunction lights off and on that clear themselves out after a little driving. Help?
__________________
2017 F80 ZCP BSM - Klein Innovation. ActiveAutowerkes. AR Design. BootMod3 Paul Johnson. EvRw. Project Gamma. RW Carbon. UCP. UUC. Hawk. Dinan. NGK. Macht Schnell. TMS. VR. aFe.
RIP - E82 135i - 7/7/2021 |
10-01-2018, 05:16 PM | #2 |
Enlisted Member
7
Rep 41
Posts |
Having the same issue. Pretty sure I have been running off just the throttle body for quite some time now. Even did the relearn procedure and it only lasted for a month. Wondering if we should just change out the VVT motor with a relearn in hopes of not having to reflash the dme or worse, change the eccentric shaft out.lol
|
Appreciate
0
|
10-12-2018, 03:57 PM | #3 | |
Colonel
441
Rep 2,038
Posts
Drives: 2017 F80 M3 ZCP BSM 2012 E82 1
Join Date: May 2012
Location: Boston, MA
|
Quote:
__________________
2017 F80 ZCP BSM - Klein Innovation. ActiveAutowerkes. AR Design. BootMod3 Paul Johnson. EvRw. Project Gamma. RW Carbon. UCP. UUC. Hawk. Dinan. NGK. Macht Schnell. TMS. VR. aFe.
RIP - E82 135i - 7/7/2021 |
|
Appreciate
0
|
10-15-2018, 09:16 AM | #5 |
Colonel
1207
Rep 2,025
Posts |
It's highly unlikely that there is damage to the eccentric shaft or camshaft just because the valvetronic motor stopped working. It's an electric motor which sees a ton of amps/heat in order to quickly spin the eccentric shaft. It just burns out over time. Replace it, or, unplug it when the car is off which should keep the eccentric shaft at max lift (that's where it defaults to when the car is off on the N55).
|
Appreciate
0
|
10-15-2018, 02:52 PM | #6 | |
Second Lieutenant
82
Rep 276
Posts |
Quote:
Have you checked the connection and remove the cover to see if some oil is coming out of the shaft area where the seal is? if the connections get oil on them from the harness, you can replace the harness for about $100 from BMW. Thatcould be the source, casing issues with the connection due to oil being at the connect between the harness and VVT motor. |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|