|
|
|
11-24-2021, 08:49 PM | #1 |
Colonel
530
Rep 2,083
Posts |
Need Torque Spec: 135i Brembo Caliper
What is the torque spec for the 10mm socket head cap screws that hold the 135i front Brembo caliper to the caliper bracket?
Thanks!
__________________
2013 135is DCT Carbon Black Metallic |
11-26-2021, 11:16 AM | #2 |
Слава Украине!
2317
Rep 2,441
Posts |
I use 110 Nm (81 lbf ft), but I don't think there is an official number.
__________________
|
Appreciate
0
|
11-28-2021, 10:57 PM | #3 |
Colonel
530
Rep 2,083
Posts |
Where did that come from?
I ended up using 60 ft-lb. I did not feel comfortable going higher than that. I also chased all the threads and reinstalled with anti-seize. I was lucky to get them out without the bolts breaking. Lots of PB Blaster and patience. I then read that removing these bolts and the 4 pins that hold in the pads is not recommended. So on the other caliper I'm not going to remove any if those. You can get the pads in/out without removing the pins. |
Appreciate
0
|
11-29-2021, 07:56 AM | #4 |
Слава Украине!
2317
Rep 2,441
Posts |
Same as the caliper bracket-to-knuckle torque.
__________________
|
Appreciate
0
|
12-11-2021, 01:31 AM | #5 |
Colonel
707
Rep 2,448
Posts |
This help?
__________________
|
Appreciate
0
|
12-12-2021, 01:51 PM | #6 |
Colonel
530
Rep 2,083
Posts |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|