Sponsored by The Tire Rack

[Okman335]

Just picked up a 2009 Titanium Silver 135i, looking in a direction for new wheels and leaning towards VMR VB3's, I like the style of the wheels and was wondering if anyone could post up some different colors on a Titanium Silver 1'er.

Thanks

[SV Concepts II]

Congratulations on the new car! You really can't go wrong with either the VB3's or the V718's on a 1 Series. Both are beautiful wheels. I know these aren't on a Titanium Silver 1'er, but here are a few shots of the V718 in Gunmetal in both 19" and 18" and one of the VB3 in 18" Matte Black.

[ModBargains III]

VMR VB3's are a great wheel. As one of the largest stocking distributors for VMR, we are proud to carry these wheels offer them to the community. Here's a few pictures of VB3's on one of the most famous 1 series around, Berk Technologies 135i Race Car:

[IMG]http://www.**********s.com/images/Products/VMR/VB3-CSL-Gallery/images/VMR-VB3-Super-Silver-Berk-Technology-135i-1.jpg[/IMG]

[IMG]http://www.**********s.com/images/Products/VMR/VB3-CSL-Gallery/images/VMR-VB3-Super-Silver-Berk-Technology-135i-2.jpg[/IMG]

[IMG]http://www.**********s.com/images/Products/VMR/VB3-CSL-Gallery/images/VMR-VB3-Super-Silver-Berk-Technology-135i-3.jpg[/IMG]

[IMG]http://www.**********s.com/images/Products/VMR/VB3-CSL-Gallery/images/VMR-VB3-Super-Silver-Berk-Technology-135i-4.jpg[/IMG]

[IMG]http://www.**********s.com/images/Products/VMR/VB3-CSL-Gallery/images/VMR-VB3-Super-Silver-Berk-Technology-135i-6.jpg[/IMG]

[IMG]http://www.**********s.com/images/Products/VMR/VB3-CSL-Gallery/images/VMR-VB3-Super-Silver-Berk-Technology-135i-7.jpg[/IMG]

I hope that helps!

[WPG D33Z]

VB3's in Hyper Black will look great! I used to run that combo on my TS E60

Is there a 19x10 offset that will work on a 1 series for the rear? The concave is massive on that wheel!

[SV Concepts II]

Originally Posted by WPG D33Z

VB3's in Hyper Black will look great! I used to run that combo on my TS E60

Is there a 19x10 offset that will work on a 1 series for the rear? The concave is massive on that wheel!

The 1 Series uses a high offset in the rear and the 19x10 VB3 isn't made with a high enough offset. 19x10 ET38 is the highest offset made for that wheel, which would require fender work. I am sure people may have tried this in the past, but it is not recommended.