|
|
|
07-27-2020, 02:00 PM | #1 |
Private First Class
44
Rep 193
Posts |
2008 E82: 676 Hifi to Logic7 Retrofit?
Been a while since posting anything on here, but found a good deal on a full L7 setup out of a 3 series and wondering what is involved.
Current setup: 676 HiFi system with CIC/Combox retrofit Potential: Logic7 System My main questions are is there anything about this that is plug and play (speaker wiring, locations, etc) and what differs from the 676 system that will need to be changed to make this work? Having done quite a few full retrofits on this car already, I am no stranger to changing things around, I would just like to know where to start. Thanks in advance. |
07-27-2020, 02:52 PM | #2 | |
Major
1084
Rep 1,048
Posts |
Quote:
I also did a Retrofit last week on my E87 based on a cheap used E91 kit (EU car). All you need to to three things.
For the Speaker best is to check at the ETK wich speaker do fit your car and which do you need to buy in addition. For the harnes you can do two variants, either replace the whole harness from with the one from the three series BMW (which are partially too long and alot of work). Or you can cut of the HIFI Connector and add the Logic 7 Connector. For this you need the following parts: 1x Main Connector 61131383502 8x Snap-in receptacle 61131376202 (maybe buy some on top 6x Snap-in receptacle 61131376204 (maybe buy some on top You may need to check if your car has already the Logic 7 amplifier holder, check here. For the Pinout you can check at TIS. For the MOST you can use the short part of your three series harness. Oh and the third method would be to have a friend who does design fully PnP Adapters to do the his retrofit and very easy to install. But don`t ask for the price, this is expensive Kri |
|
Appreciate
0
|
07-27-2020, 03:14 PM | #3 |
Private First Class
44
Rep 193
Posts |
I assume that for the MOST connector, depending on the length I need, I could just reuse the old one I looped for the MULF/TCU when I converted those to a Combox correct? No additional pins are needed other than the fiber optics?
|
Appreciate
0
|
07-27-2020, 03:42 PM | #4 | |
Major
1084
Rep 1,048
Posts |
Quote:
Your Combox does also require MOST so there is no cable free ? When using the OEM cables you need to use a cable that has a male and female connector side to install to the splitter. Kri |
|
Appreciate
0
|
07-27-2020, 04:10 PM | #5 | |
Private First Class
44
Rep 193
Posts |
Quote:
Removing the termination loop will allow that connector to be active again and my question was whether or not the amp requires anything special other than the connections to the speakers and the fiber bus. I assume that the wiring harness is what supplies the power? |
|
Appreciate
0
|
07-27-2020, 10:26 PM | #6 | |
Major
1084
Rep 1,048
Posts |
Quote:
Yes than you can use that MOST connection if it is long enough. Yes the wiring harness also supplies the same power. Kri |
|
Appreciate
0
|
07-28-2020, 08:50 AM | #7 |
Private First Class
44
Rep 193
Posts |
Do you happen to have the pinouts for the new harness? Is it just a matter of removing the pins from the HiFi harness and putting them in new spots in the L7 harness?
|
Appreciate
0
|
07-28-2020, 09:38 AM | #8 | |
Слава Украине!
2313
Rep 2,440
Posts |
Quote:
__________________
|
|
Appreciate
0
|
07-28-2020, 01:42 PM | #9 |
Private First Class
44
Rep 193
Posts |
I looked into that but its like 2K for the amp and speakers when I could get the HK setup for like 1/4 the price. I would think just the amp alone wouldn't do much for the stock HiFi setup unless Im wrong.
|
Appreciate
0
|
07-28-2020, 06:31 PM | #10 | |
Слава Украине!
2313
Rep 2,440
Posts |
Quote:
I listened to the advice of Billfitz, who is a professional speaker designer on the forums. He tested and measured the Thiele/Small parameters of the 676 speakers and found no reason to replace them. Another forum member has done the same measurements for the HK speakers. Most manufactures of car audio speakers don't publish their T/S parameters, and when they do they come up short in performance (or at best, even). We're talking high-end stuff here. Unless your speakers are blown, keep 'em. https://billfitzmaurice.info/ I expect push-back from "audiophiles" who can't imagine that their Jenhert/Morel/Audison, etc. speakers are only OK (in some cases a downgrade). Confirmation bias is a bitch. https://www.youtube.com/watch?v=BYTl...ature=youtu.be https://f30.bimmerpost.com/forums/sh...45&postcount=2 https://f30.bimmerpost.com/forums/sh...88&postcount=3 https://f30.bimmerpost.com/forums/sh...68&postcount=3
__________________
|
|
Appreciate
0
|
07-28-2020, 11:14 PM | #11 | |
Major
1084
Rep 1,048
Posts |
Quote:
E82 HIFI wiring . E82 Logic 7 wiring Kri |
|
Appreciate
0
|
08-02-2020, 12:34 PM | #12 | |
Private First Class
44
Rep 193
Posts |
Quote:
Yeah I figured it was that, I was just wondering if there was a better wiring diagram showing old pin vs new PIN number. Thanks though. |
|
Appreciate
0
|
08-12-2020, 10:20 AM | #13 |
New Member
2
Rep 16
Posts |
just made this retrofit last week, hifi to HK on my e82
went pretty good replaced all speakers, remade the wiring near the amp to adapt to HK amp plug, plugged the amp most to the loop , coded and voilá HK logic 7 upgrade...sound much better than hifi in my opinion. the only thing that i am still missing is the bracket to hold the HK amp on the back of the e82, its a expensive part and i am still thinking on a home made bracket to properly hold the amp. i only had the hifi bracket and e88 cabrio bracket, none of them fit properly. |
Appreciate
0
|
08-12-2020, 02:46 PM | #14 | |
Private First Class
44
Rep 193
Posts |
Quote:
Do you happen to have a wiring diagram showing the old vs new pin locations on the new amp plug? |
|
Appreciate
0
|
09-14-2020, 12:23 AM | #15 | ||
Enlisted Member
7
Rep 34
Posts |
Quote:
Quote:
the bracket for the harman kardon is hiding on the back seat left wall trim. i made mine work. just make a hole. |
||
Appreciate
0
|
12-24-2022, 01:56 PM | #16 | |
Private
11
Rep 54
Posts |
Quote:
Someone said they are available on Aliexpress but couldn't see any. I have a set of 752 ESP amp and speakers which I like to retrofit to my e92 hifi so even the conversion pinout would be helpful. Cheers |
|
Appreciate
0
|
Post Reply |
Bookmarks |
Thread Tools | Search this Thread |
|
|