|
|
|
02-02-2020, 02:24 AM | #1 |
Enlisted Member
6
Rep 42
Posts |
Bmw 130i low power dyno result
Hello,
The car is a 130i 265cv 2007. 4 year ago i took It to the dyno and repro was done. The car put 276hp to the flywheel. Lately i felt the engine a bit weak , the car runs and pulls to the top Rev fine and clean , iddles ok , everything normal just it feels with a bit less power like if the timming ignition id not correct. I took It to the dyno and It puts 244hp yo the flywheel do It is clear under power. The dyno os differet from the firts time but It is 32hp different to mutch for been releted yo the dyno. The car now has 50000 km more and about 14 track days. The only change i made is install a oil radiador like two mouth ago and because the car make a strange noise i put everything stock again and the noise disapear. I have no faulty Codes with Carly tool. Any idea where to start looking? Can the vanos been wrong with no error Codes? Is posible.to test vanos with a tool? Thank |
02-02-2020, 07:14 AM | #2 |
Just one more taste...
566
Rep 2,011
Posts |
Plugs, coils and replace the intake filter would be my first steps if you haven’t done those recently/at all.
If you’re pulling to 7k, it’s unlikely the ESS. |
Appreciate
0
|
02-02-2020, 08:09 AM | #3 |
Enlisted Member
6
Rep 42
Posts |
https://ibb.co/m0CWxhF
The top power is at 6900rpm, usually this engine get Max power at 6.600rpm. If you check the curve from 6000rpm is almost flat , typical dyno the power go Up till 6600rpm and them go down This is the only think that i see no normal |
Appreciate
0
|
02-03-2020, 10:51 AM | #4 |
Captain
776
Rep 992
Posts |
Failing DISA valve?
I'm not sure I even know all the reasons why the E82 will reduce power, but I would think most would throw a code. Also, if a sensor erroneously said the oil was overheating or the brakes were cooked, I would think it would reduce power by more than 30 hp. |
Appreciate
0
|
02-03-2020, 09:58 PM | #5 |
Sideways and Smiling
3027
Rep 2,860
Posts
Drives: In Exuberance
Join Date: Mar 2017
Location: Rosamond, CA USA
|
I'd bet on 4 things:
-DISA valve leaking/failed -VANOS solenoids dirty, but not bad enough to throw a code -Bad injector -Bad plugs
__________________
2012 BMW 328i 6-Speed Wagon | Deep Sea Blue with Grey Dakota Leather | Manual Swap, 330i Intake + Tune, 3.15 Helical LSD, Öhlins R&T
(SOLD) 2009 BMW 128i 6-Speed Coupé | Monaco Blue with Black Sensatec | chris_flies' 128i thread |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|