Are any of these 'tuner' fault codes?

///M1 · 05-06-2010, 10:02 AM

A BT scan done recently revealed a few 'hidden' faults. Any of these relate to a tune? Mostly the first two, the others seem unrelated.

***********************

Dynamic stability control DXC8 Plus - E90
Module Identification

5DA3:
Yaw rate sensor: DRS sends signal DrsPSIP2=INITstatus error (DRS-Typ MM 3.x).
Error will cause a warning light
Error is not currently present
Test conditions have been completed

5D93:
Valve relay: Medium or high-resistance short circuit of voltage supply FR or valve after ground registered through start-up test.
Error will cause a warning light
Error is not currently present
Test conditions have been completed

********************************
Instrument cluster PL2 E8x and E9x
Module Identification

A559:
Clamp 30g_f cutoff
Error will not cause a warning light
Error is not currently present
Test conditions have been completed

**********************************
Airbags
Module Identification

93FB:
SBR - function - Velocity signal missing
Error will not cause a warning light
Error is not currently present
Test conditions have been completed

***********************

Car Access System 3
Module Identification

A0B5:
Signal identification peed error
Error will not cause a warning light
Error is currently present
Test conditions have been completed
Short circuit or signal interruption

**********************************
Timeout
2A1A:
2A1A Tank ventilation system, function
Error will cause a warning light
Error is not currently present
Test conditions have been completed

Freeze Frame Information
Event 1Odometer 10920kms 6785miles
Engine temperature 99.00 °C
air mass calculated 103.09 mg/stk
Engine speed 640.00 rpm
corrected nominal value flow tank ventilation 0.03 kg/h

Event 2Odometer 11096kms 6894miles
Engine temperature 98.25 °C
air mass calculated 92.24 mg/stk
Engine speed 640.00 rpm
corrected nominal value flow tank ventilation 0.03 kg/h

Event 3Odometer 11112kms 6904miles
Engine temperature 99.75 °C
air mass calculated 103.09 mg/stk
Engine speed 640.00 rpm
corrected nominal value flow tank ventilation 0.03 kg/h

onefastman · 05-06-2010, 10:16 AM

Dont think so, I understand that tuner codes are stored only in the engine faults. Be sure and check for gas pedal plausibility faults though becuase if you have one of those and your clutch goes out they wont warranty it, even if the fault was a year prior.

///M1 · 05-06-2010, 10:23 AM

Quote:

Originally Posted by onefastman

Dont think so, I understand that tuner codes are stored only in the engine faults. Be sure and check for gas pedal plausibility faults though becuase if you have one of those and your clutch goes out they wont warranty it, even if the fault was a year prior.

Thx, good to know. Will be scanning the car 'prophylacticly' every few months from now on. None of these caused a CEL, in fact, I have never had a fault code since owning the car, knock on wood.

HPFREAK · 05-06-2010, 02:51 PM

Did you have the Traction control turned totally off and put it on a dyno or anything?

///M1 · 05-06-2010, 02:55 PM

Quote:

Originally Posted by Brad@PSI MOTORS

Did you have the Traction control turned totally off and put it on a dyno or anything?

Yup, I have, several times in fact. Thx Brad.

05-06-2010, 10:02 AM	#1
///M1 Brigadier General 275 Rep 3,164 Posts Drives: Many Join Date: Feb 2009 Location: North of 7K RPM iTrader: (1) Garage List 2020 BMW M2 CS [0.00] 1994 Audi RS2 Avant [0.00] 2021 Audi RS6 Avant [0.00] 1988 BMW E30 M3 [0.00] 2011 BMW 1///M [0.00] 2017 BMW F80 M3 30 ... [0.00] 2018 Porsche 991.2 GT3 [0.00] 2015 Porsche Macan ... [0.00] 1998 Porsche 993 C4S [0.00] 1994 Lancia Delta I ... [0.00] 2008 Audi RS4 [0.00]	Are any of these 'tuner' fault codes? A BT scan done recently revealed a few 'hidden' faults. Any of these relate to a tune? Mostly the first two, the others seem unrelated. ********************* Dynamic stability control DXC8 Plus - E90 Module Identification 5DA3: Yaw rate sensor: DRS sends signal DrsPSIP2=INITstatus error (DRS-Typ MM 3.x). Error will cause a warning light Error is not currently present Test conditions have been completed 5D93: Valve relay: Medium or high-resistance short circuit of voltage supply FR or valve after ground registered through start-up test. Error will cause a warning light Error is not currently present Test conditions have been completed **************************** Instrument cluster PL2 E8x and E9x Module Identification A559: Clamp 30g_f cutoff Error will not cause a warning light Error is not currently present Test conditions have been completed ****************************** Airbags Module Identification 93FB: SBR - function - Velocity signal missing Error will not cause a warning light Error is not currently present Test conditions have been completed ******************* Car Access System 3 Module Identification A0B5: Signal identification peed error Error will not cause a warning light Error is currently present Test conditions have been completed Short circuit or signal interruption ****************************** Timeout 2A1A: 2A1A Tank ventilation system, function Error will cause a warning light Error is not currently present Test conditions have been completed Freeze Frame Information Event 1Odometer 10920kms 6785miles Engine temperature 99.00 °C air mass calculated 103.09 mg/stk Engine speed 640.00 rpm corrected nominal value flow tank ventilation 0.03 kg/h Event 2Odometer 11096kms 6894miles Engine temperature 98.25 °C air mass calculated 92.24 mg/stk Engine speed 640.00 rpm corrected nominal value flow tank ventilation 0.03 kg/h Event 3Odometer 11112kms 6904miles Engine temperature 99.75 °C air mass calculated 103.09 mg/stk Engine speed 640.00 rpm corrected nominal value flow tank ventilation 0.03 kg/h __________________ 2011 BMW E82 1///M: AW, all options; Renntech, Akrapovic, Forge, P3, RevoZ CF bits, many mods 1988 BMW E30 M3: Hennarot, S14, stock 2018 Porsche 991.2 GT3: PtS, CXX, LWBS, PCCB 1998 Porsche 993 C4S: Zenith Blue, last aircooled widebody, Bilstein PSS10, Fister II + Fabspeed exhaust 2008 Audi B7 RS 4**: Sprint Blue, Audi Exclusive Euro Bucket Interior, Premium+Titanium, many mods
	Appreciate 0 Tweet Quote

05-06-2010, 10:16 AM	#2
onefastman Major General 159 Rep 5,689 Posts Drives: 2009 135i 2011 e92m dct Join Date: Sep 2009 Location: Earth iTrader: (15)	Dont think so, I understand that tuner codes are stored only in the engine faults. Be sure and check for gas pedal plausibility faults though becuase if you have one of those and your clutch goes out they wont warranty it, even if the fault was a year prior. __________________ Legal Disclaimer: Anything I or anyone else says about my vehicle on this website(1addicts.com or any affiliated or nonaffiliated sites), pertaining to modifications, is only to gain acceptance from my/our peers, and does not actually represent anything actually existing on my car, and thus, cannot be held against me in any issues, i.e. warranty claims, that may arise.
	Appreciate 0 Quote

05-06-2010, 02:51 PM	#4
HPFREAK Lieutenant Colonel 63 Rep 1,884 Posts Drives: C6 ZO6 Join Date: Sep 2009 Location: Socal iTrader: (8)	Did you have the Traction control turned totally off and put it on a dyno or anything?
	Appreciate 0 Quote