|
|
|
12-05-2022, 06:31 PM | #1 |
First Lieutenant
272
Rep 368
Posts |
Battery distribution box relocation?
Hello,
Has anyone removed the positive terminal/post connection from the distribution box and separated it with a wire? Basically, I’d like to go to a microlite battery but the battery is too small to have the whole dist. box on top so sticking it on the side of the battery would be ideal. |
12-06-2022, 02:24 PM | #2 |
Second Lieutenant
446
Rep 275
Posts |
I would think that as long as you use an appropriately sized cable it would be fine. I am using an antigravity ATX30 battery and just barely fit the dist panel, but I plan to clean up the wiring at some point.
__________________
2009 Widebody 135i ///Build Thread
Instagram: ///TheAxisGarage If you ride like lightning, you're gonna crash like thunder. |
Appreciate
0
|
12-06-2022, 05:10 PM | #3 | |
First Lieutenant
272
Rep 368
Posts |
Quote:
|
|
Appreciate
0
|
12-06-2022, 05:12 PM | #4 |
First Lieutenant
272
Rep 368
Posts |
Also, what delete plate is that? I’m doing a 1m conversion and see no need to waste money on the battery tray so I’m just allocating that to a lithium battery and blanking out the batter tray. I was planning to make a carbon fiber delete plate but if it’s cheap enough I’d buy one for sure.
|
Appreciate
0
|
12-06-2022, 05:49 PM | #5 | ||
Second Lieutenant
446
Rep 275
Posts |
Quote:
Quote:
__________________
2009 Widebody 135i ///Build Thread
Instagram: ///TheAxisGarage If you ride like lightning, you're gonna crash like thunder. |
||
Appreciate
0
|
12-06-2022, 05:52 PM | #6 | |
First Lieutenant
272
Rep 368
Posts |
Quote:
|
|
Appreciate
0
|
12-06-2022, 05:54 PM | #7 |
First Lieutenant
272
Rep 368
Posts |
I’m also removing tpms but have comfort access and I haven’t researched what the other module is. Nonetheless, the microlite battery will easily fit there on its side with some slight trimming of the foam spacer.
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|