|
|
|
09-23-2014, 01:39 AM | #1 |
Private
10
Rep 83
Posts |
o2 simulator for VRSF 3" DP
Hi guys, i recently got VRSF 3" DP and was gonna bring it in to a workshop to have them installed. The mech recommended that i get the 4 o2 simulators even though i have a JB4 installed.
He said that the JB4 will clear the CEL code, but without the o2 sims, my o2 sensors will get damaged in the long run. Can anyone out there provide an opinion on this? thanks guys |
09-23-2014, 10:19 AM | #2 |
Colonel
172
Rep 2,347
Posts |
O2 sims wont work on these motors is my understanding.
__________________
Mods:-Berkexhaust -alpinaB3flash -CobbAP -Cobb FMIC -ER charge pipe tialQ bov -M3 front sway bar -M3 subframe bushings -M3 front upper and lower control arms -M3 guide rods -M3 rear upper control arms -Mfactory LSD -defiv lockdown kit -TC Kline SA coilovers /camber plates- HP rear toe arms |
Appreciate
0
|
09-23-2014, 03:58 PM | #3 |
Major General
456
Rep 6,478
Posts |
That's a confusing question. There's nothing to "simulate" as you haven't touched the widebands or secondaries. You'll fail ready state for the catalysts but the JB will autoclear any codes so you won't notice it.
Emissions is a separate question.
__________________
E88 N54 Alpinweiss/Coral Red/Motiv HTA 3586r Tial .82AR/Other stuff...652WHP
F30 N55 XDrive EBII |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|