|
|
|
|
|
| 11-23-2019, 06:11 PM | #1 |
|
Colonel
 
122
Rep 2,199
Posts |
128i GM torque converter input shaft seal leaking
anyone replaced the input shaft seal on a gm automatic? I just completed a engine swap on a 2008 that had a bad n52. I think I damaged the seal when I installed the torque converter it's leaking pretty bad.
TIS notes some special tools needed, not sure if they are really required or a normal seal driver set is enough to get it in and out. crossing my fingers that this is all that is wrong with it!
__________________
You only need two tools in life - WD-40 and Duct Tape. If it doesn't move and should, use the WD-40. If it shouldn't move and does, use the duct tape.
Driving e82, e72, e85, R53 Gone but not forgotten.. 1974 2002, many various 3s. |
Post Reply |
| Bookmarks |
|
|
