| 10-04-2019, 01:44 AM | #1 |
|
Private
 79
Rep 69
Posts |
BMW 1M 295 squared track car
ive been looking around for the best setup for my car, and with some help from my shop JMP autowerkz in Southern california and slicer i was able to fit 295's on my 1M now for the test at buttonwillow in the following months.
|
| 10-04-2019, 05:44 AM | #2 |
|
Colonel
 
4966
Rep 2,267
Posts |
why on earth would you want 295s in the front?!
if you are going square why wouldn't you go 245 or 265 even? are you rubbing?
__________________
don't read this. too late...
|
|
Appreciate
0
|
| 10-04-2019, 09:59 PM | #4 | |
|
Private
79
Rep 69
Posts |
Quote:
|
|
|
Appreciate
0
|
| 10-05-2019, 02:56 PM | #7 |
|
Colonel
2616
Rep 2,819
Posts
Drives: e82 1M, f87 M2cs
Join Date: Nov 2011
Location: Tri-Cities, Washington
|
I run 275/35/18 square. The diameter is about 1/4" less than stock diameter on the front, and I still rub at full lock, albeit slightly.
Interestingly, I rub on the rear of the fender liner not the front (revised liners). I am lowered 20mm and run -2.5 degrees camber, stock caster. Honestly, I can't imagine how a 295 width can fit.....awaiting details
__________________
1M track toy mods: BMS chargepipe, BMS OCC, ADE FMIC, ADE motor mounts, MadDad/Lightweight Ti exhaust, ADE custom oil thermostat/cooler, custom MHD tune, F10 550i clutch, Ohlins R+T, Vorschlag camber plates, M3 'vert FSB with Turner endlinks, Stoptech Trophy BBK.
|
| 10-06-2019, 01:19 PM | #9 | |
|
Enlisted Member
 0
Rep 33
Posts |
Quote:
|
|
|
Appreciate
0
|
| 11-11-2019, 12:46 AM | #11 |
|
Enlisted Member
25
Rep 46
Posts |
I am impressed this works without rubbing.
I have 255/35/19 RE71R on stock wheels on the front and it rubs the passenger side front liner closest to the door. Does not run on forward revised linings. Did you move the washer resevoir and re mold the fender liner? |
|
Appreciate
0
|
Post Reply |
| Bookmarks |
| Thread Tools | Search this Thread |
|
|
