|
|
|
10-09-2009, 02:12 PM | #1 |
Private First Class
16
Rep 174
Posts |
JB3 just Arrived
..........
__________________
2013 f10 M5 Dinan Stage 1 Tune with Dinan Mufflers
2009 135i ESS stage 2- Sold 2000 M5 Dinan S2 SIlverstone- RIP Last edited by MFIZZLENYC; 10-12-2009 at 04:48 PM.. |
10-09-2009, 03:01 PM | #3 | |
Major
66
Rep 1,159
Posts |
Quote:
the pain in the butt part for first time installer might be the temp sensor clips. They're quite tight in the beginning (mine is completely loose now) ... but you don't wanna pull too hard coz you might break the wire. Then it is ECU's connector release lever. the Large one is very close to the edge of the ecu enclosure, so it is kinda tough to pull it out all the way. also, I still remember the first time I did it, I couldn't even get it to release more than 1/8". I've to use a small flathead to pry it loose.. good luck w/ the install. you're gonna love it, even before adaptation. |
|
Appreciate
0
|
10-09-2009, 03:36 PM | #5 | |
Private First Class
16
Rep 174
Posts |
Quote:
__________________
2013 f10 M5 Dinan Stage 1 Tune with Dinan Mufflers
2009 135i ESS stage 2- Sold 2000 M5 Dinan S2 SIlverstone- RIP |
|
Appreciate
0
|
10-09-2009, 03:36 PM | #6 |
Private First Class
16
Rep 174
Posts |
If I put it in...
__________________
2013 f10 M5 Dinan Stage 1 Tune with Dinan Mufflers
2009 135i ESS stage 2- Sold 2000 M5 Dinan S2 SIlverstone- RIP Last edited by MFIZZLENYC; 10-12-2009 at 04:50 PM.. |
Appreciate
0
|
10-09-2009, 05:36 PM | #7 |
Joint Chiefs of Staff
4918
Rep 115,980
Posts |
Just go slow and take your time.. Its pretty easy and straight forward. The most important piece of advice I can give you is take your time and NOTHING REQUIRES FORCE!! If you are really forcing something you are doing it wrong and will break something.
Mike Last edited by Mike@N54Tuning.com; 10-09-2009 at 09:17 PM.. |
Appreciate
0
|
10-09-2009, 07:27 PM | #8 | |
Private First Class
2
Rep 170
Posts |
Quote:
__________________
09 135i
|
|
Appreciate
0
|
10-09-2009, 10:14 PM | #9 |
Major General
177
Rep 6,631
Posts |
If its a PNP, its straightforward and relatively easy if you have an ounce of common sense. If it's a pinout, don't extract the yellow wires from the wrong side of the harness. It'll be a mess fixing that if you pull from the wrong side!
__________________
E90 LCI N54 6AT
|
Appreciate
0
|
10-10-2009, 06:04 PM | #10 |
Private First Class
16
Rep 174
Posts |
JB3 For sale In Long Island NY $500 bucks Jb3 PNP
__________________
2013 f10 M5 Dinan Stage 1 Tune with Dinan Mufflers
2009 135i ESS stage 2- Sold 2000 M5 Dinan S2 SIlverstone- RIP Last edited by MFIZZLENYC; 10-12-2009 at 04:49 PM.. |
Appreciate
0
|
10-10-2009, 06:08 PM | #11 | |
Joint Chiefs of Staff
4918
Rep 115,980
Posts |
Quote:
The Dinan tune doesn't stand a chance against a JB3 car Play safe out there! Mike |
|
Appreciate
0
|
10-13-2009, 12:34 PM | #12 | |
Major
129
Rep 1,243
Posts
Drives: 2012 Mini Coupe S JCW
Join Date: Oct 2008
Location: Aventura, FL
|
Quote:
Actually.... The only lead was gained from wheel spin top of first in the 335. otherwise was exactly the same! Blame it on weight difference... No inching what so ever. A fender from what was stated above.
__________________
Back again after 10 yrs!
Daily: 2012 Mini coupe S JCW Baby: 2007 BMW M6 Vert Wifey's: 2006 BMW 650I Family: 2007 Chevy Suburban LTZ |
|
Appreciate
0
|
10-13-2009, 05:52 PM | #13 |
Private First Class
16
Rep 174
Posts |
ok ok how bout some were in the middle of these 2 claims!!!!! LOL
__________________
2013 f10 M5 Dinan Stage 1 Tune with Dinan Mufflers
2009 135i ESS stage 2- Sold 2000 M5 Dinan S2 SIlverstone- RIP |
Appreciate
0
|
10-14-2009, 02:54 AM | #15 |
First Lieutenant
11
Rep 305
Posts |
sometimes one ticket is all you need ...
like the one I got for exhibition and unsafe left turn (because trying to stick me with exhibition wasn't enough!)...end result was it didn't stick but if it did it would've been 2 pts for 7 years (like a dui). like mike says... |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|