|
|
|
02-09-2013, 09:19 PM | #1 |
OneThirty5Eye
105
Rep 250
Posts |
JB4 -Misfire with Map 2 only?
1- I have been running JB4 for a couple of months now. I have been running Map 1 with DCI and 93 octane...The car runs great under map 1. I recently installed BMS downpipes. However, when I switch to Map 2 I often get a misfire code for Cylinder 2. I have done pull after pull to see if the JB4 simply has to "learn" but after many pulls the problem remains. Map 2 runs ok when I WOT from a higher speed (60 roll) but misfires when I WOT at lower speeds/gears (20-30mph). Can running this extra 1.5 psi cause the car to go from having ZERO misfires on map1 to misfires almost EVERY time with map 2? Or do you think there is another culprit causing this issue?
Also 2- Based on your experience...I have an Automatic Transmission...my car's oil temp easily hits 250 degrees but doesnt really go past that after some spirited driving. A day after installing my BMS downpipes I noticed that my car seemed to be hesitant to shift from 3rd to 4th at WOT...its almost seems like it stalls before the shift...and on occastion the exhaust would sound like its makes a fart noise between shifts, as if its having a hard time breathing. I have no experience with aftermarket downpipes. Does this seem normal? Do you think the 250 degrees can cause the transmission to not preform to its full potential? Any help from those with Jb4/DP experience would be greatly appreciated. Thanks |
02-09-2013, 10:41 PM | #2 |
Captain
60
Rep 654
Posts |
What JB4 version and what software revs are you running? What are your settings?
Post a log and an image of your user adjustable settings. Have you run map 5 and do you get the same results. It sounds like you are referring to what to me sounds like retarded timing during a shift...sort of like a NLS (No Lift Shift), for me this was very noticeable when I was running restricted boost levels in 1st and 2nd. Pretty sure it was also the case in map 2 and know it was it map 6 but at the time I didn't put it together and haven't revisited it as map 2 ran like crap for me at the time and there is no reason for me to run it. I'll probably dial map 6 in later but for now...map 5.
__________________
2008 E88--Fuel-It! Stage 4 LPFP & PI--PS2 turbos--JB4/MHD--FBO--662whp/604wtq
2011 E90--Fuel-It! S2BL LPFP and PI--PS2 Turbo--JB4/MHD--FBO--546whp/589wtq 2013 Mini JCW--Tune--DP--FMIC--a couple Fuel-It! goodies--265whp/320wtq 2013 F10--JB4/BM3 2015 F82--Fuel-It! Stage 3 LPFP & PI--PS2 Turbos-- JB4/BM3-FBO |
Appreciate
0
|
02-10-2013, 11:29 AM | #3 |
2020 Z4 M40i - 2022 M4C Convt
3121
Rep 5,264
Posts
Drives: 2020 Z4 M40i - 2022 M4C Convrt
Join Date: Jun 2011
Location: Raleigh, NC - OIB, NC
iTrader: (0)
Garage List 1965 COBRA (FFR rep ... [8.57]
2023 Jeep Wrangler ... [9.50] 2009 Yamaha V-Star [0.00] Cars 2-BMW, 2-FORD, ... [0.00] 2023 Ford Expeditio ... [0.00] 2020 Z4 M40i [10.00] 2022 BMW M4C [7.25] 1998 FORD Ranger 4X4 [0.00] |
If you have over 25K on your plugs they could be the problem. Yes a pound & a half can be enough to cause a misfire if your car was already near the edge.
I run a custom map 6 & ramped up 1/2 pound at a time with Terry reviewing the logs. Got to bad logs then backed down 1/2 pound.
__________________
Kevin
Dravit Gray, Black Leather, Moonlight Roof, Red Calipers 2022 M4C - 2020 Z4 M40i - 2023 FORD Expedition XLT Max 4X4 400BHP - 2009 V-Star - 1998 Ranger 4X4 5MT - 1965 Cobra (R) 5MT - 2023 Jeep Wrangler Sport S 6MT |
Appreciate
0
|
Post Reply |
Bookmarks |
Tags |
downpipe, jb4, map 2, misfire, misfiring |
Thread Tools | Search this Thread |
|
|