|
|
|
10-05-2022, 06:52 PM | #1 |
Colonel
122
Rep 2,199
Posts |
ekpm2 coding for e100 / higher amp load
anyone coded their ekpm2 module for e100 / higher amp load to remove the error when running a stage2 LPFP
I attempted with protool but it says coding is not available for the control unit EKPM60_3_03 i'll admit I've not loaded it up in ncsdumy yet to see if they have predefined the values for removing the amp draw error
__________________
You only need two tools in life - WD-40 and Duct Tape. If it doesn't move and should, use the WD-40. If it shouldn't move and does, use the duct tape.
Driving e82, e72, e85, R53 Gone but not forgotten.. 1974 2002, many various 3s. |
10-06-2022, 10:42 AM | #2 |
Private
16
Rep 70
Posts |
ekpm
I was getting the error when I upgraded to stage 2 LPFP which was making the car undriveable. I tried the Protools fix, but I still kept getting the warning. Finally, I had two options, replace the ekpm with a brand new oem unit, or go with something like the Eospeed. The Eospeed unit is always out of stock, and it's been like that for months. So I replaced mine with a brand new oem unit and the error message hasn't come back since.
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|