|
|
|
|
|
|
| ||||||||||||||||
Post Reply |
|
|
Thread Tools | Search this Thread |
| 06-27-2018, 11:34 AM | #1 |
|
Private
 15
Rep 66
Posts |
automatic to manual, in a car that already had a manual...
Ok long story short;
car had manual transmission blew motor bought new motor which was attached to automatic transmission no longer have original engine harness new engine harness is missing backup light switch cable to back of transmission is the clutch module wiring part of a different harness that is possibly still in the car, or is that wiring missing along with the original engine harness? |
| 07-11-2018, 12:30 PM | #2 |
|
Lieutenant
 
278
Rep 400
Posts |
Clutch switch is it’s own wiring. It may be tucked away if the installer was wise. There are 4 wires, if I remember correctly, that come out of the switch/sensor. The sensor slides into the side of the master cylinder. The trans has a harness that connects to the dme and there is 1 wire from there that goes to the lcm to activate the back up lights. You also have to code the lcm to get the signal active.
|
|
Appreciate
0
|
Post Reply |
| Bookmarks |
|
|
