'09 BSM modified 135i

c0ris07 · 05-14-2016, 10:45 PM

New family car has arrived and its time for the 135 to go #dadlyf

Car has been in my family (previously my fathers) since new so know the complete history. Was completely stock when I bought it off my old man.

Extremely well maintained and tastefully modded. Anyone ready to chase big power, this is the perfect car. Prior to family I was headed down that road but now have to call it a day.

Have heaps of photos and receipts throughout the build. I still have most stock parts (have a garage full of stock parts) that will go with the car too.

2009 (first registered Jan '10) BSM with 84,000km

Engine
aFe Stage 2 closed intake
AMS intercooler
VRSF catless downpipes
ER Charge pipe
Turbosmart Dual Port Compact kit
BMS oil catch can
RB turbo modified PCV
RB turbo PCV cap
RB turbo oil thermostat delete plate
Improved Racing inline 185deg thermostat with custom braided lines
ER Sport Racing oil cooler with shroud
Fuel-it Stage 2 fuel pump setup
NGK 5992 plugs
Dimple magnetic drain plug

Driveline
Spec Stage 3 clutch
Spec Single Mass Steel flywheel
Wavetrac LSD
VAC billet diff cover
Nolathane diff bushings
BMS Short Shifter
BMS clutch stop
Modified clutch valve
Dimple g/box magnetic sump plug

Suspension
M3 front upper/lower control arms
M3 Rear upper arms
Nolathane rear subframe bushings
Ohlins Road and Track dampers with
Swift 7" front springs
Swift 9" rear springs
Vorshlag Camber plates (also have Ground Control Street camber plates to be supplied)
1M front strut brace conversion

Brakes
Stoptech BBK custom painted and M logo'd
ST-60 front calipers
355x32 2 piece front discs
ST-40 rear calipers
345x28 2 piece rear discs
Street performance pads

Wheels
Advan RSII in Hyper Black
18x8.5 +35 fronts with BRAND NEW Michellin PS3 225/45
18x9.5 +50 rears with conti extreme DW 255/35
Project Kics REVO R40 closed end nuts
Wheel stud conversion

Exterior/Interior
Blackline rear lights
BMWLED angel eyes
ZHP shift knob
Black grilles
Carbon boot spoiler
Carbon rear diffuser
LED interior lights
M3 cowl
FLOW front lip
FLOW side splitters

Got the car with 60,00km's on it and since then have done...

Opti coat paint protection
Intake valve clean
Oil filter housing gasket
Valve cover gasket and new valve cover
Redline MTL g/box oil
Motul RBF600 brake flush
Motul Diff fluid
Cooling system flush
New Delphi coil packs
New boost solenoids
New Silicon vacuum lines

Located in Adelaide SA

Looking for $36,500
Chris 0412824503

jaze55 · 05-15-2016, 02:38 AM

If you were in Sydney I would be taking this off your hands, value for money considering the modifications installed.

PeteA · 05-15-2016, 06:01 AM

Good luck with sale. Those brakes still look golden

dane083 · 05-15-2016, 06:59 AM

Quote:

Originally Posted by jaze55

If you were in Sydney I would be taking this off your hands, value for money considering the modifications installed.

Its like a $200 plane ticket and a long weekends drive.

PeteA · 05-15-2016, 07:19 AM

Or $500 on the back of a truck

questionable · 05-15-2016, 07:35 AM

I doubt this will even last a week

kmli5 · 05-15-2016, 07:49 AM

PMed

OzJustin · 05-15-2016, 09:17 AM

Very well sorted car. If I were to give up my paddle shift for a manual car then this would be a very tempting option. Good luck with the sale (although I doubt you'll need it).

c0ris07 · 05-15-2016, 04:20 PM

Thanks guys. This is definitely a car worth traveling for.

Nugget · 05-18-2016, 01:52 AM

Looks like a very well modified car. Should be a good buy for someone.

K-Bag · 05-19-2016, 02:22 AM

Where the hell were you 6 weeks ago when I was looking in SA!!! I had to buy a bloody 135 from Perth!

With these mods and condition I would have taken 1 drive and handed you a wad of cash.

Oh well, best of luck with your sale. I'm sure you will find the right buyer soon enough.

c0ris07 · 05-20-2016, 01:36 AM

Quote:

Originally Posted by K-Bag

Where the hell were you 6 weeks ago when I was looking in SA!!! I had to buy a bloody 135 from Perth!

With these mods and condition I would have taken 1 drive and handed you a wad of cash.

Oh well, best of luck with your sale. I'm sure you will find the right buyer soon enough.

ummm sorry?

lol

you can always sell your car and pick up mine

vtl · 05-20-2016, 01:52 AM

*cough* part out *cough*

K-Bag · 05-20-2016, 02:17 AM

Its all good, I was looking for a 135 for ages, but there was only like 3 for sale in SA at the time.

If my one wasn't on a lease I would seriously consider selling and re buying. But alas 4 years and 10 months to go.......

dane083 · 05-20-2016, 02:43 AM

Quote:

Originally Posted by K-Bag

Its all good, I was looking for a 135 for ages, but there was only like 3 for sale in SA at the time.

If my one wasn't on a lease I would seriously consider selling and re buying. But alas 4 years and 10 months to go.......

You know you can swap "securities" on most leases right? I.e. exchange cars. Trade yours in, buy his adn swap security....

c0ris07 · 05-26-2016, 12:05 AM

BUMP before I chuck her on carsales!

froop · 05-26-2016, 02:27 AM

+1 on parting out lol

Dibs on brakes if you do :P

If not, good luck with the sale dude! Really nicely modded.

c0ris07 · 06-11-2016, 12:34 AM

BUMP price drop 36,500

05-14-2016, 10:45 PM	#1
c0ris07 Second Lieutenant 25 Rep 216 Posts Drives: BMW 135i Join Date: Nov 2013 Location: South Australia iTrader: (4)	'09 BSM modified 135i New family car has arrived and its time for the 135 to go #dadlyf Car has been in my family (previously my fathers) since new so know the complete history. Was completely stock when I bought it off my old man. Extremely well maintained and tastefully modded. Anyone ready to chase big power, this is the perfect car. Prior to family I was headed down that road but now have to call it a day. Have heaps of photos and receipts throughout the build. I still have most stock parts (have a garage full of stock parts) that will go with the car too. 2009 (first registered Jan '10) BSM with 84,000km Engine aFe Stage 2 closed intake AMS intercooler VRSF catless downpipes ER Charge pipe Turbosmart Dual Port Compact kit BMS oil catch can RB turbo modified PCV RB turbo PCV cap RB turbo oil thermostat delete plate Improved Racing inline 185deg thermostat with custom braided lines ER Sport Racing oil cooler with shroud Fuel-it Stage 2 fuel pump setup NGK 5992 plugs Dimple magnetic drain plug Driveline Spec Stage 3 clutch Spec Single Mass Steel flywheel Wavetrac LSD VAC billet diff cover Nolathane diff bushings BMS Short Shifter BMS clutch stop Modified clutch valve Dimple g/box magnetic sump plug Suspension M3 front upper/lower control arms M3 Rear upper arms Nolathane rear subframe bushings Ohlins Road and Track dampers with Swift 7" front springs Swift 9" rear springs Vorshlag Camber plates (also have Ground Control Street camber plates to be supplied) 1M front strut brace conversion Brakes Stoptech BBK custom painted and M logo'd ST-60 front calipers 355x32 2 piece front discs ST-40 rear calipers 345x28 2 piece rear discs Street performance pads Wheels Advan RSII in Hyper Black 18x8.5 +35 fronts with BRAND NEW Michellin PS3 225/45 18x9.5 +50 rears with conti extreme DW 255/35 Project Kics REVO R40 closed end nuts Wheel stud conversion Exterior/Interior Blackline rear lights BMWLED angel eyes ZHP shift knob Black grilles Carbon boot spoiler Carbon rear diffuser LED interior lights M3 cowl FLOW front lip FLOW side splitters Got the car with 60,00km's on it and since then have done... Opti coat paint protection Intake valve clean Oil filter housing gasket Valve cover gasket and new valve cover Redline MTL g/box oil Motul RBF600 brake flush Motul Diff fluid Cooling system flush New Delphi coil packs New boost solenoids New Silicon vacuum lines Located in Adelaide SA Looking for $36,500 Chris 0412824503 Attached Images Last edited by c0ris07; 06-11-2016 at 12:35 AM..
	Appreciate 1 Tweet Quote

05-15-2016, 02:38 AM	#2
jaze55 Enlisted Member 7 Rep 31 Posts Drives: m140i Join Date: May 2014 Location: Australia iTrader: (0)	If you were in Sydney I would be taking this off your hands, value for money considering the modifications installed.
	Appreciate 0 Quote

05-15-2016, 06:01 AM	#3
PeteA Major 127 Rep 1,054 Posts Drives: E30, E82 Join Date: Sep 2012 Location: Melbourne iTrader: (3)	Good luck with sale. Those brakes still look golden __________________ Pete's Build Thread Last edited by PeteA; 05-15-2016 at 06:21 AM..
	Appreciate 0 Quote

05-15-2016, 07:19 AM	#5
PeteA Major 127 Rep 1,054 Posts Drives: E30, E82 Join Date: Sep 2012 Location: Melbourne iTrader: (3)	Or $500 on the back of a truck __________________ Pete's Build Thread
	Appreciate 0 Quote

05-15-2016, 07:35 AM	#6
questionable S50B32 40 Rep 415 Posts Drives: E30 318is Join Date: Apr 2014 Location: Australia iTrader: (1)	I doubt this will even last a week
	Appreciate 0 Quote

05-15-2016, 07:49 AM	#7
kmli5 Private First Class 10 Rep 183 Posts Drives: E92 M3 Join Date: Mar 2012 Location: Melbourne iTrader: (1)	PMed __________________ 2008 BMW M3 \| 6MT \| OEM Exhaust Mod \| Black Grilles \|
	Appreciate 0 Quote

05-15-2016, 09:17 AM	#8
OzJustin Lieutenant 77 Rep 541 Posts Drives: 2008 135i AT Monaco Blue Join Date: Dec 2012 Location: Brisbane, Australia iTrader: (0) Garage List 2008 BMW 135i [8.66]	Very well sorted car. If I were to give up my paddle shift for a manual car then this would be a very tempting option. Good luck with the sale (although I doubt you'll need it). __________________ My Build Thread
	Appreciate 0 Quote

05-15-2016, 04:20 PM	#9
c0ris07 Second Lieutenant 25 Rep 216 Posts Drives: BMW 135i Join Date: Nov 2013 Location: South Australia iTrader: (4)	Thanks guys. This is definitely a car worth traveling for.
	Appreciate 0 Quote

05-18-2016, 01:52 AM	#10
Nugget Colonel 650 Rep 2,601 Posts Drives: G81 M3 Touring, GR Supra GTS Join Date: Jan 2012 Location: Perth iTrader: (2) Garage List 2011 BMW 135i [10.00]	Looks like a very well modified car. Should be a good buy for someone.
	Appreciate 0 Quote

05-19-2016, 02:22 AM	#11
K-Bag Private 19 Rep 81 Posts Drives: 2016 OG M2 Join Date: Feb 2016 Location: Newcastle iTrader: (0)	Where the hell were you 6 weeks ago when I was looking in SA!!! I had to buy a bloody 135 from Perth! With these mods and condition I would have taken 1 drive and handed you a wad of cash. Oh well, best of luck with your sale. I'm sure you will find the right buyer soon enough.
	Appreciate 0 Quote

05-20-2016, 01:52 AM	#13
vtl Brigadier General 1493 Rep 3,148 Posts Drives: 2008 BMW 135i MT Join Date: Apr 2015 Location: Melbourne, Australia iTrader: (0)	cough part out cough __________________ Build Thread
	Appreciate 0 Quote

05-20-2016, 02:17 AM	#14
K-Bag Private 19 Rep 81 Posts Drives: 2016 OG M2 Join Date: Feb 2016 Location: Newcastle iTrader: (0)	Its all good, I was looking for a 135 for ages, but there was only like 3 for sale in SA at the time. If my one wasn't on a lease I would seriously consider selling and re buying. But alas 4 years and 10 months to go.......
	Appreciate 0 Quote

05-26-2016, 12:05 AM	#16
c0ris07 Second Lieutenant 25 Rep 216 Posts Drives: BMW 135i Join Date: Nov 2013 Location: South Australia iTrader: (4)	BUMP before I chuck her on carsales!
	Appreciate 0 Quote

05-26-2016, 02:27 AM	#17
froop Colonel 171 Rep 2,682 Posts Drives: 08 AW 6MT E82 Join Date: Jul 2012 Location: Sydney, Australia iTrader: (3)	+1 on parting out lol Dibs on brakes if you do :P If not, good luck with the sale dude! Really nicely modded. __________________ froop's AW 135i Build Thread
	Appreciate 0 Quote

06-11-2016, 12:34 AM	#18
c0ris07 Second Lieutenant 25 Rep 216 Posts Drives: BMW 135i Join Date: Nov 2013 Location: South Australia iTrader: (4)	BUMP price drop 36,500
	Appreciate 0 Quote