|
|
|
02-19-2020, 09:51 PM | #23 |
Registered
0
Rep 3
Posts |
Hello! I have a 2010 128i. I put in seats from a 2010 3 series and also the console. I have the airbag light on and I have tried to clear it but it stays on. I was told to get a passenger seat occupancy emulator bypass but I do not know which one to get. I also have a black wire which not plugged into anything underneath both seats which i believe is the seat occupancy sensor for the OE seats. Where does this plug into or does it? It sits right next to the yellow box 😐
|
Appreciate
0
|
02-19-2020, 11:46 PM | #24 | |
Major General
4335
Rep 6,196
Posts |
Quote:
|
|
Appreciate
0
|
02-24-2020, 10:52 AM | #25 | |
Lieutenant
348
Rep 573
Posts |
Quote:
__________________
2011 Space Grey 135i DCT:
Pure Stage 2, Fuel-it Stage 2 LPFP, ST XTA Coilovers, Berk Street Axle Back, MHD Stage 2+, VRSF Catless DP, VRSF 5" FMIC, VRSF LCP, BMS UCP, M3 FSB, e92 M3 Drivers Seat. |
|
Appreciate
0
|
02-24-2020, 01:34 PM | #26 |
Registered
0
Rep 3
Posts |
Hey is it possible for you to show me a picture where the sensor gets plugged in on the seat rail? And also what did you do about the plug for the active headrests? You just left it hanging...lol?
|
Appreciate
0
|
Post Reply |
Bookmarks |
Thread Tools | Search this Thread |
|
|