|
|
|
04-08-2019, 01:05 PM | #1 |
Colonel
530
Rep 2,083
Posts |
Wagner FMIC Install - N55
Have anyone installed one of these recently? I just installed a Wagner EVO 1 Competition FMIC and ended up having to use the black spacers between the intercooler and radiator support, but the instructions say this is not necessary for 135i and 335i. Without the spacers the stepped part of the intercooler would hit whatever is right above it.
With the spacers it seems to fit well but hangs down pretty low and rubs the belly pan.
__________________
2013 135is DCT Carbon Black Metallic |
04-08-2019, 01:14 PM | #2 | |
BXR
575
Rep 636
Posts |
Quote:
__________________
2012 135i M Sport Alpine White
|
|
Appreciate
0
|
04-08-2019, 02:02 PM | #3 |
Colonel
530
Rep 2,083
Posts |
I actually did not have this issue with my VRSF 5" stepped FMIC.
__________________
2013 135is DCT Carbon Black Metallic |
Appreciate
0
|
04-08-2019, 03:04 PM | #5 |
BXR
575
Rep 636
Posts |
Are you running with or without the spacers?
__________________
2012 135i M Sport Alpine White
|
Appreciate
0
|
04-08-2019, 03:15 PM | #6 |
Loves me some MHD!
1857
Rep 1,718
Posts |
Are y'all trying not to trim plastic for vertical clearance?
__________________
1and1
135i - E82.N54 2009 BSM - MHD / xHP / DCI, PR CP & 7.5" Race IC / N55 mid & Borla . . WL RSFI, Koni, Eibach & Dinan CP's, M3 CA's / EBC Red's & Firehawk 500's X1 - E84.N20 2013 MGM - JB4 - The Wife's, now with new turbo & ewg |
Appreciate
0
|
04-08-2019, 03:21 PM | #8 |
Colonel
530
Rep 2,083
Posts |
I did not do any cutting. Wagner claims a no-cut install and doesn't mention any cutting in the instructions. There was a small plastic piece that is removed, but it pops right out w/o cutting
Last edited by ferocity02; 04-08-2019 at 03:45 PM.. |
Appreciate
0
|
04-08-2019, 09:51 PM | #9 |
Private
14
Rep 54
Posts |
I installed the Wagner Evo 1 Performance in a 2012 135i and didn't even see any mention of spacers. So no spacers and it fits fine. It does hang down maybe 3/8" lower than the stock intercooler and the only way I know that is I have a funky driveway that I had to model in Autocad and model the car in Autocad. Installed ramp sections to clear the car in certain spots. Well, after the intercooler install, now it's scraping right at the intercooler. So time to redo the ramps.
|
Appreciate
0
|
04-11-2019, 08:45 PM | #10 |
Joint Chiefs of Staff
24094
Rep 190,631
Posts |
Should fit fine without any spacers
__________________
Check out our current sale by clicking on this link!
https://x-ph.com/sale/ Phone number 702-494-9435 |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|