|
|
|
04-12-2019, 11:19 AM | #1 |
First Lieutenant
188
Rep 327
Posts |
I have a 9/2010 2011 135i coupe.
Last March I purchased the crank capture piece directly from Vargas. After removing the 8 small bolts holding the balancer on, I can not get the piece to slide far enough over the hex of the crank bolt to sit flush against the balancer. All of the pictures I have seen online show the piece sitting flush with the end of the crank bolt. Mine sits flush with the end of the crank bolt, but leaves 1/8-1/4" gap beneath it as if there is supposed to be a spacer involved. There are no markings on the part itself. I don't know if I was shipped the wrong part, though it states S55/N55 on my invoice. There is a different part on their site for N54, but the pics look the same. I tried calling them yesterday, but they do not provide product support over the phone. I sent them an email through the form on their site and have not received a reply yet. Has anyone else installed one of these and had this issue? I tried the search option, but didn't find anything. Thank you |
Post Reply |
Bookmarks |
|
|