|
|
|
Yesterday, 03:22 PM | #1 |
Lieutenant
332
Rep 530
Posts |
128i - harness above engine, plastic clip mounts
Somehow, the three mounts that hold the wiring harness (above the motor) in place have broken, see pictures. What do I need to do to fix this? Plastic gets brittle w heat
|
Yesterday, 06:33 PM | #2 |
Second Lieutenant
436
Rep 286
Posts |
I don't know for sure without seeing it in person or looking at my car and I'm a bit too lazy to do that rn.
I think you either need 12527532268 or 12527534161. I could be wrong, double check realoem diagrams (i found these under Engine Electrical System).
__________________
2011 BMW 128i 6MT M Sport - Alpine White on Terracotta w/ Glacier-Silver trim - Koni Yellows w/ H&R Sport Springs, M3 Control Arms, Euro Intake, BMW Performance Exhaust, 3.73 Diff w/ RacingDiffs LSD Conversion, Black Line Taillights, M Performance Grilles, lots-o-maintenance
|
Appreciate
0
|
Today, 01:28 AM | #3 |
Second Lieutenant
87
Rep 268
Posts |
I think this might be the lower part of the cabin microfilter compartment, part #2 on this page: https://www.realoem.com/bmw/enUS/sho...diagId=64_1428
I also have the driver's side tabs broken off, and the center is not held up very solidly, either. A fragile part that isn't inexpensive. Good luck.
__________________
E9x M3 front & rear suspension arms; BMW Performance brakes upgraded to drilled rotors in rear; BMW performance shifter; BMW Performance Exhaust; Wave Trac LSD with modified 'nannies'; BMW Euro Intake box; BMW Aluminum Strut Tower bar; ECS front and rear sway bars; 3 stage intake with BPC software; BMW style 78, 17 x 8" wheels with Bridgestone RE 980AS 225/45-17 tires; Koni Special Active struts/shocks, E9x M3 RTABs.
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|