|
|
|
04-01-2019, 08:50 PM | #1 |
Private
2
Rep 55
Posts |
Sport Seat Swap wiring
Evening all!
Ive searched everywhere I know so hopefully ya'll can answer this one for me I just bought full power sport seats for my 128 replacing my full power heated, memory non sport seats. Everything installed fine except since the Sport seats have the lumbar and the side bolster switches my original harness doesn't have those wires in it to power it. I found the wiring diagrams and see where the hot wire would go and ive disassembled the connector and confirmed its not there. Is there a safe reliable way to connect power to the seat side of the harness to power up these without having to run wires back to the fuse box? Can it be jumped from an existing hot wire in the vehicle side? any help would be greatly appreciated. |
05-01-2019, 05:38 PM | #2 |
Registered
0
Rep 4
Posts |
Were you able to make this work? What model is the seat out of? I recently did the same swap and everything worked perfectly. Check out this post for more info.
https://www.1addicts.com/forums/show....php?t=1493435 |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|