BMW 1 Series Coupe Forum / 1 Series Convertible Forum (1M / tii / 135i / 128i / Coupe / Cabrio / Hatchback) (BMW E82 E88 128i 130i 135i)


Post Reply
Thread Tools Search this Thread
      11-15-2013, 08:29 PM   #1

Drives: 2011 E82 135i, 2015 F15 X5 35D
Join Date: Dec 2010
Location: NY

iTrader: (2)

Garage List
2020 BMW X5 40i  [0.00]
2011 BMW 135i  [0.00]
Very bad stalling issue.

Okay so I installed the BMS cowl filters today and I removed the two plastic cowl pieces that are on top of the engine. I drove for about one hour until my car stalled on me out of no where, did not think much of it as the N55 has stalling issues. I drive further down the block and as I come to the stop it stalls again. When I go to turn the car back on again as the revs come down to idle it just falls straight down again and stalls on me.

Just to be clear, the car has not stalled on me on its own in over 6 months, ever since I switched one of the JB4 sensors back to stock as Mike from BMS suggested. Which worked because it has not stalled on me since then, until now of course. There are no codes, no service engine light, no limp mode, nothing...every time the car gets under 10 mph it just stalls and if I turn it on and do not give it any gas it will stall again.

I left the car off for about an hour maybe that would let everything reset or something and I could not even make it down the block without it continuously stalling on me.

Does anybody have any ideas as what it could be or if maybe I did something wrong?
Appreciate 0
Post Reply


Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 03:55 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2020, vBulletin Solutions Inc.,,,,,,,,, logo and trademark are properties of BIMMERPOST