Rear manzo camber bars

[spxxx]

Any reviews? What's the max negative camber people are getting with these?

[jvb6806]

I am in no way trying to be a troll... but how much rear camber are you looking for? I have -2* and room to go further with the factory eccentric bolts.

[spxxx]

Originally Posted by jvb6806

I am in no way trying to be a troll... but how much rear camber are you looking for? I have -2* and room to go further with the factory eccentric bolts.

More looking for ease of adjustment tbh

[drunkenup]

I want to say it made a difference with rear end stability. Changes made at the same time were, going to -2 deg from -1.7 deg camber and going from MPSS to Direzza Z2SS.

Car no longer wheel hops when spinning- feels more planted too, I think.

Toe spec will change a little while tightening down the adjustment nuts. It can be a little frustrating to get just right.

[StealYourFace]

The toe arms made me feel stiffer sub frame bushing un needed.

[spxxx]

Originally Posted by StealYourFace

The toe arms made me feel stiffer sub frame bushing un needed.

interesting, this is news to me. I'm just starting to focus on the rear end of my car and have Rogue toe arms and manzo camber arms waiting to be installed.

I don't think I'll end up installing the camber arms, I found a good deal but they don't seem to add much performance if you can get -2* out of the stock setup.

I also have a set of the black Powerflex rear position subframe bushings to install to replace my current subframe inserts - I don't see an issue running just the rear position with only inserts on the front bushings? This would make the DIY a lot easier but may increase wear on the rear bushings...