01-05-2012, 09:09 PM | #1 |
New Member
6
Rep 18
Posts |
Speed limit warning coding
Hi guys,
I previously posted this thread in the DIY section of the 1 series but did not get any answer yet so I was thinking I could be a bit more lucky here: http://www.1addicts.com/forums/showthread.php?t=631663 Let me know guys. It's bugging me quite a bit. Thanks! |
04-16-2012, 12:32 PM | #2 |
New Member
6
Rep 18
Posts |
Have done it!
I had given up a couple of months ago (much rather drive the car!). Could not find the right package, I was not properly also, hihi... but decided to have a go at it again today. And I've done it: I successfully coded out this annoying speed limit warning using ncsexpert!
Just a recap: In Dubai, new cars have this mandatory speed limit warning at 120 km/h. On the 1M if you listen to music a tad loud, the DONG is kinda crazy even though it's adjusted to the minimum in the Idrive menu. Back to my story... The few seconds wait while the s/w was re-programming my ECU may have been the most stressful moment I've had in a while First time coding so you know... I was just hoping the car would start after!!! But it did and all is good!! And no more DONNGGG!! Anybody in the same situation let me know, I could send you the correct package for the e82. Back to driving!! |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|