OFHG oil lines

[And11]

Doing OFHG v2 () along with VC and wanted to double check if these oil cooler lines look seated correctly. Can anyone double check?



My H bolt is a 13mm and tightened to 19Nm already
https://www.newtis.info/tisv2/a/en/e...-lines/5eUhA4L

[MightyMouseTech]

Does not look seated right. Looks like you pinched the Oring on the left side. You can see it sticking out.

[vtl]

That just looks like a shadow

[And11]

Thanks for the replies.

Actually do the o-rings go further down on the bottom section? This is how they're currently seated

[vtl]

Originally Posted by And11

Thanks for the replies.

Actually do the o-rings go further down on the bottom section? This is how they're currently seated

[IMG]https://www.dropbox.com/s/72xiuwdypy...jpg?dl=0&raw=1[/IMG]

That's installed correctly

[And11]

Originally Posted by vtl

That's installed correctly

Thanks vtl! Took it for a spin without the engine cover and wow the injector noise is noticeable. That cover does quite a job suppressing the noise.