|
|
|
03-30-2021, 03:30 AM | #1 |
Second Lieutenant
40
Rep 224
Posts |
fk8 type R spec'd rims ??
So with the Fk8 type R getting older, i seen some jdm branded rims come up. Theree fitment is a 5x120 and wondered has anyone tried out the type r fitment+38 offsets or perhaps found a reverse staggered set ranging from 8.5 9.5 widths?
__________________
e84 x1 2012 Sdrive2.0d sold was a fun car in stick
|
04-07-2021, 06:48 PM | #2 |
Major General
3520
Rep 6,702
Posts |
The FK8 Type R centerbore is smaller than the BMW 72.56mm CB. If the wheel is made to be a direct fit on the Type R, you will need to have the centerbore of the wheels machined out to BMW spec before using.
-Tom
__________________
925-245-0773 /// info@apexraceparts.com
Wheels /// Accessories /// Vehicle-Specific Fitment Guides /// Careers |
Appreciate
0
|
05-02-2021, 09:51 AM | #3 |
Second Lieutenant
40
Rep 224
Posts |
thanks for the response ! yea i think some manufacturers like rays sets the centerbore to 75mm so hubrings may be required. But the offset of et 38 going to be a stretch for the rear wheels
__________________
e84 x1 2012 Sdrive2.0d sold was a fun car in stick
|
Appreciate
1
Expert@ApexWheels3520.00 |
Post Reply |
Bookmarks |
|
|