Lambda control 2

[ATM135]

So I keep getting code 2c32 lambda control 2. I don’t see a lot of info on this. Not to sure on what’s causing it. Anyone have info on this? Could it possibly have to do with the vanos solenoids? I would appreciate any input. Thanks

[PiggoBenis]

Did you recently replace/install downpipes/exhaust and/or replace your o2 sensor? I had the same issue when I had an exhaust leak after a downpipe install. See below for the common faults for that specific code:

2C32 - Lambda probe in front of catalytic converter, trimming control*** Typically caused by the wrong O2 sensors in the wrong downpipe or a major exhaust leak. Grey wire loom goes to the back pipe, black wire loom goes to the front pipe.

Dave