|
|
|
09-12-2017, 01:46 PM | #1 |
Banned
173
Rep 615
Posts |
Brake light wiring
Just did a manual swap on my 135i and my brake lights are constantly on. I know you're supposed to run a wire from the transmission to the nfrm. The wiring diagram runs that transmission wire through a connector and goes to the nfrm. What's the connector in the middle??
|
09-13-2017, 08:57 AM | #2 |
Lieutenant
288
Rep 408
Posts |
Your brake light switch needs to be pushed back in towards the pedal. When you do the swap it has a tendency to move back.
the wire you are supposed to run to the nfrm is the reverse wire. the brake light wires stay the same |
Appreciate
0
|
09-13-2017, 09:32 AM | #3 |
Banned
173
Rep 615
Posts |
Thanks very much. I'll look at that today. I could do without the reverse light for a bit
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|