|
|
|
09-08-2014, 07:05 PM | #1 |
Enlisted Member
5
Rep 41
Posts |
Steering wheel off center
So i installed some downpipes on my 135 this weekend. The install went pretty good other than the knuckle smashing that happened with the o2 sensors. I have noticed that my steering wheel is no longer centered. its slightly off pointing to the right when im going straight. Is there some adjustment that i should have done before i bolted the steering rack back up??
Thanks, |
09-08-2014, 07:39 PM | #2 |
Private First Class
35
Rep 181
Posts |
things can get out of wack when the wheels are hanging and the wteering rack is off. Unless your wheels were perfectly still and not bumped or moved (and even then your prolly not going to be safe) i'm assuming you had it up on jacks or something. If so you changed the steering geometry by taking it apart, letting the wheels hang, and then putting back together.
go get an alignment and you should be fine
__________________
Fuel-it.biz|Cobb|Pure Turbos|ActiveAutowerk
Berk|BMS|Evolution Racewerks|M GmbH VMR|StopTech|EBC|Michelin|Nitto Royal Purple|Motul|Mann Filters|LUX |
Appreciate
0
|
09-08-2014, 11:10 PM | #3 | |
Major
341
Rep 1,293
Posts |
Quote:
If you chose to adjust the tie rods, make equal changes on each side so your total toe is not changed. Start by marking the top of the steering wheel with a piece of tape. If your steering wheel is pointing right, this should be left of center. Now get under the car and make a mark on the tie rod with another piece of tape or a sharpie. Use a T-50 torx wrench (or a 16mm socket) to loosen the pinch bolt. The T-50 is preferable since the 16mm bolt face is very thin and can strip easily. Use a 13mm wrench to turn the tie rods paying special attention to the threads to make sure you are turning the tie rod in the intended direction. Again, you want to make sure both tie rods are adjusted the same amount so that both wheels are pointed more to the right/passenger side. A little adjustment goes a long way. One full turn (360 degrees) will result in a 10-15 degree change in the steering wheel angle. Write down how much you changed each side (e.g. full turn, 1/2 turn, 1/4 turn, etc.). Tighten the pinch bolts and go for a drive. Unless you're super lucky, the steering wheel will not be centered. Mark the new top of the steering wheel with tape. Now you know the distance that the steering wheel changed as a result of your first adjustment. Knowing this distance, and how much you rotated the tie rods, you can determine how much further to go, or how much to back off your initial adjustment. |
|
Appreciate
0
|
09-09-2014, 11:43 AM | #4 |
Enlisted Member
5
Rep 41
Posts |
Awesome. Thanks for your help guys
|
Appreciate
0
|
09-09-2014, 12:42 PM | #5 |
Major
82
Rep 1,051
Posts |
Being even 0.5 degree off on toe can be pretty bad. I would not suggest messing with it. I would let a pro with precision measurement equipment handle it.
You can DIY alignment, but it's a very involved process to get acceptable precision in a home garage.
__________________
2009 BMW 135i 6MT Sport, AFE intake, Cobb AP, Apex 18x8.5+9.5, 255/275 PSS
|
Appreciate
0
|
09-09-2014, 08:16 PM | #7 |
Enlisted Member
5
Rep 41
Posts |
Sounds good. I guess it's going to the shop
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|